Serial Port - Digi Connect IT 16 User Manual

Serial port

Exclusive access: enabled
n
Idle timeout: 15m
n
Reversed mode: disabled
n
Note You can also configure the serial port by using Device Configuration > Serial. Changes made by
using either Device Configuration or Serial Configuration will be reflected in both.
To change the configuration to match the serial configuration of the device to which you want to
connect:

WebUI
1. Log into the Connect IT 16/48 WebUI as a user with Admin access.
2. On the menu, click System. Under Configuration, click Serial Configuration.
The Serial Configuration page is displayed.
Use the
n
Select the number of Ports per page that you want to display. Click the appropriate
n
number or click ALL to display all ports. You can also click Next or Back to display the
next or previous set of ports.
Note
on the device.
3. Click on the port name to expand the port you want to configure.
The Settings section that display depend on the mode selected for the port. If Remote Access
is selected, all sections display. If Login or Power Management are selected, only the Serial
Settings section displays.
Note The serial port is enabled by default. To disable the serial port, toggle off Enable.
Digi Connect IT® 16/48 User Guide
Search ports field to limit the list of ports displayed on the page.
The number ports you can display is determined by the number of ports available
Configure the serial port
161