Table of Contents
Advertisement
Services
Repeat this step to list additional firewall zones.
8. 1. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
2. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Forward location information to a remote host
You can configure location clients on the Connect IT 16/48 device that forward location messages in
either NMEA or TAIP format to a remote host.
Required configuration items
Enable the location service.
n
The hostname or IP address of the remote host to which the location messages will be
n
forwarded.
The communication protocol, either TCP or UDP.
n
The destination port on the remote host to which the messages will be forwarded.
n
Message protocol type of the messages being forwarded, either NMEA or TAIP.
n
Digi Connect IT® 16/48 User Guide
Type ... firewall zone ? at the config prompt:
(config)> ... firewall zone ?
Zones: A list of groups of network interfaces that can be
referred to by packet
filtering rules and access control lists.
Additional Configuration
---------------------------------------------------------
----------------------
any
dynamic_routes
edge
external
internal
ipsec
loopback
setup
(config)>
Location information
377
Advertisement
Table of Contents
