Configure Device Two (Backup Device) - Digi Connect IT 16 User Manual

Hide thumbs Also See for Connect IT 16:

Table of Contents

2. Set the DHCP server gateway type to custom:

(config)> network interface eth2 ipv4 dhcp_server advanced gateway custom

3. Set the custom gateway to 192.168.3.3:

(config)> network interface eth2 ipv4 dhcp_server advanced gateway_custom

4. Save the configuration and apply the change:

(config)> save

Configuration saved.

5. Type exit to exit the Admin CLI.

Depending on your device configuration, you may be presented with an Access selection

menu. Type quit to disconnect from the device.

Configure device two (backup device)

Task 1: Configure VRRP on device two

1. Log into the Connect IT 16/48 WebUI as a user with full Admin access rights.

2. On the menu, click System. Under Configuration, click Device Configuration.

The Configuration window is displayed.

3. Click Network > VRRP.

4. For Add VRRP instance, type a name for the VRRP instance and click .

The new VRRP instance configuration is displayed.

Digi Connect IT® 16/48 User Guide

Virtual Router Redundancy Protocol (VRRP)

Connect it 48