Debug An Ipsec Configuration - Digi Connect IT 16 User Manual

Hide thumbs Also See for Connect IT 16:

Table of Contents

Virtual Private Networks (VPN)

1. Log into the Connect IT 16/48 command line as a user with Admin access.

Depending on your device configuration, you may be presented with an Access selection

menu. Type admin to access the Admin CLI.

2. To display details about all configured IPsec tunnels, type the following at the prompt:

> show ipsec all

3. To display details about a specific tunnel:

> show ipsec tunnel ipsec1

4. Type exit to exit the Admin CLI.

Depending on your device configuration, you may be presented with an Access selection

menu. Type quit to disconnect from the device.

Debug an IPsec configuration

If you experience issues with an IPsec tunnel not being successfully negotiated with the remote end of

the tunnel, you can enable IPsec debug messages to be written to the system log. See

and event logs

for more information about viewing the system log.

There are two methods to enable IPsec debug messages:

From the Admin CLI—Sets the debug level to 1 (basic debugging information only).

From the interactive shell—Allows for more detailed debug information.

Use the Admin CLI to set the IPsec debug level to 1

To set the debug level to 1 by using the Admin CLI:

Command line

1. Log into the Connect IT 16/48 command line as a user with full Admin access rights.

Depending on your device configuration, you may be presented with an Access selection

menu. Type admin to access the Admin CLI.

Digi Connect IT® 16/48 User Guide

---------------

: 192.168.2.1

Connect it 48