Table of Contents
Advertisement
Services
Use a dead reckoning external USB GNSS receiver
The Connect IT 16/48 device supports an external USB GNSS receiver to provide dead reckoning-
based location information. The USB GNSS receiver is available for purchase from Digi International
Inc..
The ability to use an external USB GNSS receiver is enabled by default. After purchasing the
USB GNSS receiver, plug it into a USB port on the Connect IT 16/48, and it will begin providing location
information.
To disable support for the external GNSS receiver, or enable it if it has been disabled:
WebUI
1. Log into the Connect IT 16/48 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Services > Location > Location sources > usb.
4. Click Enable the location source to disable the USB GNSS receiver, or to enable it if it has
been disabled.
5. Alternatively, you can also delete the usb location source:
a. Click the menu icon (...) next to the usb location source.
b. Click Delete.
6. Click Apply to save the configuration and apply the change.
Command line
1. Log into the Connect IT 16/48 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
Digi Connect IT® 16/48 User Guide
Location information
370
Advertisement
Table of Contents
