Hardware Specifications; Power Supply; Electrical Rating - Digi Connect IT 16 User Manual

Hide thumbs Also See for Connect IT 16:

Table of Contents

Power and fan item

Hardware specifications

Input rating for redundant dual power

Operating temperature

The Connect IT 16 or 48 must be operated only with power supplies from a Digi-provided power supply

kit, either ITPS-PSIK (for Port Side Air Intake) or ITPS-PSIK (for Port Side Air Exhaust), as appropriate

for the device installation location.

The Connect IT 16 and Connect IT 48 devices require an appropriate power cable that meets national

standards to connect to a standard outlet. The appropriate requirements are listed per region:

EU/International: VDE Mark, conforming to IEC 60083, IEC 60227, or IEC 60320, with C13 to

the appropriate national mains connector, 2 x 0.75 mm2.

USA/Canada: UR Mark, conforming to UL 62, UL 817, or CSA-C22.2, with C13 to 1-15P, 5-15P,

or NEMA locking connector, 18 AWG.

Digi Connect IT® 16/48 User Guide

The LED lights up when the Connect IT starts up or

you have activated the

Flashing blue: The LED flashes blue once per

second when the Connect IT starts up or you

have activated the find me feature. When

starting up, the WWAN Signal, WWAN Service,

and Status LEDs on the back of the Connect IT

Solid blue: The Connect IT initialization is

Red: The Connect IT has had start-up failure.

Connect the fan unit to the device.

For installation information, see

supplies and

Connect the second power supply and fan unit to the

For installation information, see

supplies and

2.4 A maximum for each power

0° C - 50° C

Hardware specifications

Connect the power

Connect it 48