Configure The Speed Of Your Ethernet Ports - Digi Connect IT 16 User Manual

System administration
Gateway: 192.168.210.1
n
2. Connect the PC's Ethernet port to the ETH1 Ethernet port on your Connect IT 16/48 device.
3. Open a telnet session and connect to the Connect IT 16/48 device at the IP address of
192.168.210.1.
4. Log into the device:
Username: admin
n
Password: The default unique password for your device is printed on the device label.
n
5. At the shell prompt, type:
# rm /etc/config/.nocrypt
# flatfsd -i
This will re-enable encryption and leave the device at its factory default setting.

Configure the speed of your Ethernet ports

You can configure the speed of your Connect IT 16/48 device's Ethernet ports.

WebUI
Digi Connect IT® 16/48 User Guide
Configure the speed of your Ethernet ports
619