Table of Contents
Advertisement
Services
Configure SSH access
The Connect IT 16/48's default configuration has SSH access enabled, and allows SSH access to the
device from authorized users within the Internal firewall zone. If this configuration is sufficient for
your needs, no further configuration is required. See
SSH
for information about configuring the SSH service to allow access from remote devices.
Required configuration items
Enable SSH access.
n
Configure access control for the SSH service.
n
Additional configuration items
Port to use for communications with the SSH service.
n
Multicast DNS (mDNS) support.
n
A private key to use for communications with the SSH service.
n
See
Set the idle timeout for Connect IT 16/48 users
timeout for the SSH service.
Enable or disable the SSH service
The SSH service is enabled by default. To disable the service, or enable it if it has been disabled:
WebUI
1. Log into the Connect IT 16/48 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Services > SSH.
4. Click Enable.
5. Click Apply to save the configuration and apply the change.
Command line
Digi Connect IT® 16/48 User Guide
Allow remote access for web administration and
for information about setting the inactivity
Configure SSH access
341
Advertisement
Table of Contents
