Show Nemo Status - Digi Connect IT 16 User Manual

Hide thumbs Also See for Connect IT 16:

Table of Contents

Virtual Private Networks (VPN)

The default is defaultroute.

13. Configure one or more local networks to use as a virtual NEMO network interface. Generally,

this will be a Local Area Network (LAN):

a. Add a local network to use as a virtual NEMO network interface:

(config vpn nemo nemo_example)> add network end eth2

(config vpn nemo nemo_example)>

b. (Optional) Repeat for additional interfaces.

14. Save the configuration and apply the change:

(config)> save

Configuration saved.

15. Type exit to exit the Admin CLI.

Depending on your device configuration, you may be presented with an Access selection

menu. Type quit to disconnect from the device.

Show NEMO status

1. Log into the Connect IT 16/48 WebUI as a user with Admin access.

2. On the menu, select Status > NEMO.

The NEMO page appears.

3. To view configuration details about an NEMO tunnel, click the  (configuration) icon in the

upper right of the tunnel's status pane.

Command line

1. Log into the Connect IT 16/48 command line as a user with Admin access.

Depending on your device configuration, you may be presented with an Access selection

menu. Type admin to access the Admin CLI.

2. To display details about all configured NEMO tunnel, type the following at the prompt:

Digi Connect IT® 16/48 User Guide

ii. Set the interface. For example:

(config vpn nemo nemo_example)> tun_local interface eth1

(config vpn nemo nemo_example)>

Connect it 48