Enable Service Discovery (Mdns) - Digi Connect IT 16 User Manual

Services
5. Add Ethernet devices:
a. Use the ? to determine available devices:
(config network bond name)> ... network device ?
Additional Configuration
-----------------------------------------------------------------------
-----
eth1
eth2
loopback
sfp1
sfp2
(config network bond name)>
b. Add a device:
(config network bond name)> add device /network/device/eth1
(config network bond name)>
c. Repeat to add additional devices.
6. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Enable service discovery (mDNS)

Multicast DNS mDNS is a protocol that resolves host names in small networks that do not have a DNS
server. You can enable the Connect IT 16/48 device to use mDNS.

WebUI
1. Log into the Connect IT 16/48 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Services > Service Discovery (mDNS).
4. Enable the mDNS service.
5. Click Access control list to configure access control:
Digi Connect IT® 16/48 User Guide
Enable service discovery (mDNS)
427