Table of Contents
Advertisement
Diagnostics
capture_ping
> analyzer start name
You can capture up to 10 MB of data traffic in two 5 MB files per interface.
Note
Data traffic is captured to RAM and the captured data is lost when the device reboots unless you
save the data to a file. See
Stop capturing packets
You can stop packet capture at the command line with the
To stop packet capture from the command line:
Command line
1. Log into the Connect IT 16/48 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Type the following at the Admin CLI prompt:
> analyzer stop name capture_filter
>
where capture_filter is the name of a packet capture configuration. See
capture for the network analyzer
To determine available packet capture configurations, use the ?:
> analyzer stop name ?
name: Name of the capture filter to use.
Format:
test_capture
capture_ping
> analyzer stop name
Show captured traffic data
To view captured data traffic, use the
following information for each packet:
The packet number.
n
The timestamp for when the packet was captured.
n
The length of the packet and the amount of data captured.
n
Whether the packet was sent or received by the device.
n
The interface on which the packet was sent or received.
n
Digi Connect IT® 16/48 User Guide
Save captured data traffic to a
for more information.
show analyzer
file.
analyzer stop
command.
Configure packet
command. The command output show the
Analyze network traffic
680
Advertisement
Table of Contents
