Setting And Adding Devices; Setting Integrated Ups Parameters - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual
1.
2.
3.
Step 2 Choose System Settings > Smart Module Settings, modify Smart module name, and click
Submit in the Site ID area.
----End

5.3 Setting and Adding Devices

5.3.1 Setting Integrated UPS Parameters

Prerequisites
In this example, a straight-through cable is used to connect the integrated UPS to the POE
port on the smart ETH gateway.
Procedure
Step 1 Start the integrated UPS, and tap System Info on the LCD.
Step 2 Choose System Info > Settings, enter the user name admin and password 000001, and then
tap
Issue 07 (2020-03-16)
 By default, the system type displayed on the web page is the system type selected last time. Change
the system type as required.
 If the system type is changed, the monitoring software will restart and you can log in to the WebUI
again after 3 minutes.
Select FusionModule2000 from the System Type drop-down list box.
Click Submit in the System Type area.
Figure 5-1 Setting the system type
Go to the Re-authentication page, enter the login user name and password, and click
Submit.
. In the displayed dialog box for confirming the password, tap OK.
If you enter incorrect passwords for three consecutive times, you will be locked out for 5 minutes.
Copyright © Huawei Technologies Co., Ltd.
5 Power-On Commissioning
86