Huawei ECC800 User Manual page 164

ECC800 Data Center Controller
User Manual
Step 3 Hold down the BLINK button on a device such as a smart ETH gateway for less than 1s to
report the blinking status to the ECC800. The corresponding device icon in the WebUI plan
view blinks. Check that the device positions and types in the plan view are consistent with the
actual situation by delivering the blinking command.
Figure 5-39 Example plan view without room monitoring
Figure 5-40 Example plan view with room monitoring
----End
Follow-up Procedure
To modify the smart module plan view, perform the following steps:
1.
2.
3.
Issue 07 (2020-03-16)
 If a room-level access control device and camera exist, drag them to the equipment room view.
 You can click the camera icon in the view to display the camera web page.
Choose Home > Plan View.
Click Modify Device in Smart Module View. The Devices is displayed.
Drag registered devices (for example, the camera) to the appropriate positions in the
layout diagram and click Exit Edit Mode. The smart module plan view is updated.
Copyright © Huawei Technologies Co., Ltd.
5 Power-On Commissioning
155