How To Set And Add A Pmac625 Ac Meter - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual
Procedure
Step 1 Set the ATS device address. On the ATS display panel, choose Device Configuration >
Modbus and set the device address.
Step 2 Add an ATS.
1.
2.
Table 5-12 Adding an ATS
Path
Choose System
Settings >
Device
Management
and click Add
Device. The
parameters for
adding devices
are displayed.
3.
----End

5.3.15 How to Set and Add a PMAC625 AC Meter?

Prerequisites
One end of the straight-through cable has been connected to the RS485 port on the PMAC625
AC meter, and the other end has been connected to the COM port on the ECC800.
Issue 07 (2020-03-16)

The ATS device address is 1 by default.
 The initial password is 0001 for the ATS display panel.
Log in to the ECC800 WebUI as an administrator.
Add an ATS.
Parameter
Name
Device attribute
Device Type
Connect To
Communications
Port
Device Address
Click Test Connect to check whether the ATS connects to the ECC800 properly.
− If the ATS connects to the ECC800 properly, click Confirm. The connected devices
are displayed in the Number of connected devices list.
If the ATS does not connect to the ECC800 properly, check whether the cable
−
between the ATS and the ECC800 is connected properly, whether the ATS and
ECC800 are running properly, and whether the input parameters are consistent with
the ATS parameters.
Copyright © Huawei Technologies Co., Ltd.
Setting
Select ATS from the drop-down list box.
Select ATS from the drop-down list box.
Select ECC800 from the drop-down list box.
Select COM1 from the drop-down list box.
NOTE
The setting example indicates that the ATS is connected to
the COM1 port on the ECC800. If the ATS is connected to
another port, enter the number of the connected port.
In this example, Device Address is set to 1. During
actual configuration, set the device address for the
ATS based on the actual situation.
5 Power-On Commissioning
104