Huawei ECC800 User Manual page 146

ECC800 Data Center Controller
User Manual
1.
2.
3.
4.
5.
6.
Issue 07 (2020-03-16)
(Optional) In the scenario with the ring network of the smart ETH gateway, disconnect
the communications cable of the smart ETH gateway from one LAN port of the ECC800
and use a network cable to connect a PC to the LAN port of the ECC800.
(Optional) In the scenario without the ring network of the smart ETH gateway, use a
network cable to connect a PC to an idle POE port of the smart ETH gateway.
Configure the PC IP address and IP address of the LAN port on the ECC800 in the same
network segment.
Access the ECC800 WebUI and choose System > Video Settings.
Click Search in the Search for Video Device IP Address list.
 The search timeout interval is 10s. If the search fails, a search failure message is displayed.
 To find the exact camera IP address, multiple searches are recommended.
Figure 5-17 Searching for the camera IP address
The possible camera IP addresses will be displayed in the Search Result list. Click the
link under Link (PC IP Address and LAN IP Address Should Be in the Same
Network Segment) to access the camera WebUI, log in to the WebUI, set Ways to
obtain IP to Use the following IP address, and set the IP address in the range of
192.168.248.50 to 192.168.248.99.
Copyright © Huawei Technologies Co., Ltd.
5 Power-On Commissioning
137