Commissioning A Electrode Water Sensor - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual
Step 3 Set water sensor parameters.
1.
2.
3.
Step 4 Check functions of water sensors.
Table 5-25 Function commissioning
Check Method
Immerse the water detection
cable in water.
----End

5.5.3.3 Commissioning a Electrode water sensor

If a water sensor is installed, perform the following steps to configure it.
Context



Procedure
Step 1 Set water sensor parameters.
1.
2.
3.
4.
5.
6.
Issue 07 (2020-03-16)
water sensor and ECC800 are running properly, and whether the input parameters
are consistent with the water sensor parameters.
Log in to the ECC800 WebUI as an administrator.
Choose Monitoring > System > Water Sensor > Running Parameters.
Set the parameters based on actual conditions, and click Submit.
To use the AI/DI sensor, enable the corresponding AI/DI port and name the sensor. The
specific alarm then can be reported.
If the sensor is prefabricated, only check its settings.
The actual value prevails. Only the method of the parameter settings is described.
In this example, the water sensor is connected to the AI/DI_3 port on the ECC800.
Log in to the ECC800 WebUI as an administrator.
Choose System Settings > Signal Name Modify. The Batch Signal Configuration
page is displayed.
Set Device Type to ECC800, set Device Name to ECC800, and click OK.
On the query result tab page, set the new signal name of AI/DI_3 to Leak and click
Submit.
Choose Monitoring > System > ECC800 > Running Parameters > AI/DI_3 Port
Settings.
Set Leak sensor to Enable and click Submit.
Copyright © Huawei Technologies Co., Ltd.
Normal Connection Status
 Choose Monitoring > System > Water Sensor >
Running Info. Check that Leakage status is
Alarm and Distance from the leakage point is
greater than 0 m.
 Choose Home > Active Alarms. Check that a
water sensor alarm is generated.
5 Power-On Commissioning
119