Adding A Ip Device - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual
1.
2.
Table 5-17 Adding an independent deployment AI_DI unit
Path
Choose System
Settings >
Device
Management
and click Add
Device. The
parameters for
adding devices
are displayed.
3.
----End

5.3.19 Adding a IP Device

Prerequisites


Issue 07 (2020-03-16)
Log in to the ECC800 WebUI as an administrator.
Add an independent deployment AI_DI unit.
Parameter
Name
Device
attribute
Device type
Connect to
Communicatio
ns port
Device
address
Click Test Connect to check whether the independent deployment AI_DI unit connects
to the ECC800 properly.
a. If the independent deployment AI_DI unit connects to the ECC800 properly, click
Confirm. The connected devices are displayed in the Number of connected
devices list.
b. If the independent deployment AI_DI unit does not connect to the ECC800 properly,
check whether the cable between the independent deployment AI_DI unit and the
ECC800 is connected properly, whether the independent deployment AI_DI unit
and ECC800 are running properly, and whether the input parameters are consistent
with the parameters of the independent deployment AI_DI unit.
A IP device is connected to the ECC800 over a switch. The device and ECC800 have
been powered on.
You have obtained the IP address of the IP device.
Copyright © Huawei Technologies Co., Ltd.
Setting
Select Independent Deployment AI_DI Unit from
the drop-down list box.
Select Independent Deployment AI_DI Unit from
the drop-down list box.
Select ECC800 from the drop-down list box.
Select COM3 from the drop-down list box.
NOTE
The setting example indicates that the independent
deployment AI_DI unit is connected to the COM3 port on
the ECC800. If the independent deployment AI_DI unit is
connected to another port, set the COM port to the ECC800
port connected to the independent deployment AI_DI unit.
In this example, Device address is set to 1. During
actual configuration, set the device address for the
independent deployment AI_DI unit based on the
actual situation.
5 Power-On Commissioning
110