How Should I Add Devices Accessed Through The Eth Converter To The Ecc800 Webui - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual
9.1.21 How Should I Add Devices Accessed Through the ETH
Converter to the ECC800 WebUI?
Context
Figure 9-7 Network diagram
Procedure
Step 1 Set communications parameters on the device.
Table 9-1 Description of communications parameters to be set on a device
Parameter
Baud rate
Communications address
Step 2 Add the device to the ECC800 WebUI.
1.
2.
Issue 07 (2020-03-16)
Log in to the ECC800 WebUI as the administrator.
Add the device.
Copyright © Huawei Technologies Co., Ltd.
Recommended Value
This section uses 9600 as an example. Set this parameter
based on site requirements.
NOTE
For certain devices, this parameter does not need to be set.
This section uses 1 as an example. Set this parameter based on
site requirements.
9 FAQ
201