Huawei ECC800 User Manual page 134

ECC800 Data Center Controller
User Manual
Toggle switches 1 to 6 of the DIP switch specify the device address in binary mode. ON
indicates 1, and OFF indicates 0.
Table 5-33 Setting a device address
Address Toggle
Switch 1
1 ON
2 OFF
3 ON
4 OFF
Step 2 Add a T/H sensor.
1.
2.
Table 5-34 Adding a T/H sensor
Path
Choose System
Settings >
Device
Management
and click Add
Device. The
parameters for
adding devices
are displayed.
3.
Step 3 Check functions of the T/H sensor.
Issue 07 (2020-03-16)
Toggle
Switch 2
OFF
ON
ON
OFF
Log in to the ECC800 WebUI as an administrator.
Add a T/H sensor.
Parameter
Name
Device attribute
Device type
Connect to
Communications
port
Device address
Click Test Connect to check whether the T/H sensor connects to the ECC800 properly.
− If the T/H sensor connects to the ECC800 properly, click Confirm. The connected
devices are displayed in the Number of connected devices list.
− If the T/H sensor does not connect to the ECC800 properly, check whether the cable
between the T/H sensor and the ECC800 is connected properly, whether the T/H
sensor and ECC800 are running properly, and whether the input parameters are
consistent with the T/H sensor parameters.
Copyright © Huawei Technologies Co., Ltd.
Toggle Toggle
Switch 3 Switch 4
OFF OFF
OFF OFF
OFF OFF
ON OFF
Setting
Select Sensor from the drop-down list box.
Select T/H sensor from the drop-down list box.
Select ECC800 from the drop-down list box.
Select COM3 from the drop-down list box.
NOTE
The setting example indicates that the T/H sensor is
connected to the COM3 port on the ECC800. If the T/H
sensor is connected to another port, enter the number of
the connected port.
In this example, Device address is set to 1. During
actual configuration, set the device address for the
T/H sensor based on the actual situation.
5 Power-On Commissioning
Toggle Toggle
Switch 5 Switch 6
OFF OFF
OFF OFF
OFF OFF
OFF OFF
125