Huawei ECC800 User Manual page 110

ECC800 Data Center Controller
User Manual
Step 2 Add a PDU2000.
1.
2.
Table 5-9 Adding a PDU2000
Path
Choose System
Settings >
Device
Management
and click Add
Device. The
parameters for
adding devices
are displayed.
3.
----End
Issue 07 (2020-03-16)
Figure 5-6 PDU2000-M (H) communications settings
− Press DOWN and UP to select the address to be set.
− Press MENU to confirm the settings.
If modification is successful,
displayed:
Log in to the ECC800 WebUI as an administrator.
Add a PDU2000.
Parameter
Name
Device attribute
Device Type
Connect To
Communications
Port
Device Address
Click Test Connect to check whether the PDU2000-M connects to the ECC800
properly.
− If the PDU2000 connects to the ECC800 properly, click Confirm. The connected
devices are displayed in the Number of connected devices list.
− If the PDU2000 does not connect to the ECC800 properly, check whether the cable
between the PDU2000 and the ECC800 is connected properly, whether the
PDU2000 and ECC800 are running properly, and whether the input parameters are
consistent with the PDU2000 parameters.
Copyright © Huawei Technologies Co., Ltd.
is displayed: If modification fails,
Setting
Select PDU from the drop-down list box.
Select PDU2000-M (C) or PDU2000-M (H) from
the drop-down list box based on the actual device.
Select ECC800 from the drop-down list box.
Select COM1 from the drop-down list box.
NOTE
The setting example indicates that the PDU2000 is
connected to the COM1 port on the ECC800. If the
PDU2000 is connected to another port, enter the number
of the connected port.
Enter the actual device address of the PDU2000.
5 Power-On Commissioning
is
101