Huawei ECC800 User Manual page 212

ECC800 Data Center Controller
User Manual
Context
Figure 9-8 Network diagram
Procedure
Step 1 Set communications parameters on the device.
Table 9-3 Description of communications parameters to be set on a device
Parameter
Baud rate
Communications address
Step 2 Add the device to the ECC800 WebUI.
1.
2.
Table 9-4 Parameter description for adding a device
Path
Choose System
Settings >
Device
Management
and click Add
Device. The
parameters for
adding devices
are displayed.
Issue 07 (2020-03-16)
Log in to the ECC800 WebUI as an administrator.
Add the device.
Parameter
Device attribute
Device type
Connect to
Communications
port
Copyright © Huawei Technologies Co., Ltd.
Recommended Value
This section uses 9600 as an example. Set this parameter
based on site requirements.
NOTE
For certain devices, this parameter does not need to be set.
This section uses 1 as an example. Set this parameter based on
site requirements.
Setting
Select the device attribute to be accessed from the
drop-down list box.
Select the device type to be accessed from the
drop-down list box.
Select ECC800 from the drop-down list box.
Select COM1 from the drop-down list box.
NOTE
The setting example indicates that the device connects to
the COM1 port on the ECC800. If the device connects to
9 FAQ
203