Commissioning A Smoke Sensor (Connected To The Ai/Di Port On The Skylight Actuator) - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual
4.
5.
6.
7.
Step 2 Check the monitoring functions of smoke sensor.
Table 5-21 Commissioning the sensor
Check Method
Simulate a smoky
environment under
the smoke sensor.
----End
5.5.2.2 Commissioning a Smoke Sensor (Connected to the AI/DI port on the
skylight actuator)
If a smoke sensor is installed, perform the following steps to configure it.
Context


Procedure
Step 1 Set smoke sensor parameters.
1.
2.
3.
Issue 07 (2020-03-16)
On the query result tab page, set the new signal name of AI/DI_3 to Smoke and click
Submit.
Choose Monitoring > System > ECC800 > Running Parameters > AI/DI_3 Port
Settings.
Set Smoke sensor to Enable and click Submit.
Confirm that Smoke sensor type is automatically identified as Smoke Sensor or Smoke
sensor(NC). Ensure that Smoke power supply is Yes.
Normal Connection Status
Smoke DI alarm is displayed on
the active alarm page of the app
or WebUI.
If the sensor is prefabricated, only check its settings.
The actual value prevails. Only the method of the parameter settings is described.
In this example, the smoke sensor is connected to the AI/DI_1 port on the skylight actuator.
Log in to the ECC800 WebUI as an administrator.
Choose Monitoring > Aisle > Skylight Actuator Group > Skylight Actuator 1 >
Running Parameters.
Set DI1 alarm level to Low voltage alarm or High voltage alarm, and click Submit.
 Set DI1 alarm level to Low voltage alarm if the smoke sensor is connected over NO.
 Set DI1 alarm level to High voltage alarm if the smoke sensor is connected over NC.
Copyright © Huawei Technologies Co., Ltd.
5 Power-On Commissioning
Alarm Clearance Method
 If Smoke sensor type is set
to Smoke Sensor, power off
and reset the smoke sensor to
clear the alarm.
 If Smoke sensor type is set
to Smoke Sensor(NC), press
the reset button of the smoke
sensor to clear the alarm.
116