Huawei ECC800 User Manual page 227

ECC800 Data Center Controller
User Manual



The following are descriptions of the WebUI:



Table 10-1 Logic list button introduction
Button
Add
Insert
Modify
Delete
Activate
Deactivate
Issue 07 (2020-03-16)
Configure PLC logic programs on the WebUI for display.
Enable or disable each or all logic programs.
Import or export configuration files.
Basic Parameters: The configurations of the PLC logic programs are valid if Enable
PLC function is set to Yes.
Logic List: You can configure logic program lines.
Import and Export: You can import or export configuration files to generate logic
program lines in batches.
Description
Used to add a PLC linkage condition.
Used to insert a PLC linkage condition before another PLC linkage
condition.
Used to modify a PLC linkage condition.
Used to delete a PLC linkage condition.
Used to activate a PLC linkage condition.
Used to deactivate a PLC linkage condition. Note that after a PLC
linkage condition is deactivated, other PLC linkage conditions that
use the output of this condition will be affected.
Copyright © Huawei Technologies Co., Ltd.
10 PLC Introduction
218