Commissioning A Smoke Sensor; Commissioning A Water Sensor - Huawei ECC800 User Manual

ECC800 Data Center Controller
User Manual

5.9.2 Commissioning a Smoke Sensor

If a smoke sensor is installed, perform the following steps to configure it.
Procedure
Step 1 Set smoke sensor parameters.


Step 2 Check the monitoring functions of smoke sensor.
Table 5-25 Commissioning the sensor
Check Method
Simulate a smoky
environment under
the smoke sensor.
Step 3 (Optional) Set audible and visual alarm linkage function for the smoke sensor based on
requirements. You can follow the instructions in linking alarms with alarm beacon.
----End

5.9.3 Commissioning a Water Sensor

If a water sensor is installed, perform the following steps to configure it.
Issue 06 (2020-01-02)
 If the sensor is prefabricated, only check its settings.
 The actual value prevails. Only the method of the parameter settings is described.
Scenario 1: Connect the smoke sensor to the AI/DI port on the ECC800 (AI/DI_1 is used
as an example).
On the WebUI, choose Monitoring > System > ECC800 > Running Parameters >
AI/DI_1 Port Settings, set AI/DI_1 sensor to Enable, and click Submit. Set AI/DI_1
sensor name to Smoke sensor, check that AI/DI_1 sensor type is set to Smoke Sensor
or Smoke Sensor(NC), and click Submit.
Scenario 2: Connect the smoke sensor to the AI/DI port on the skylight actuator
(AI/DI_1 is used as an example).
On the WebUI, choose Monitoring > Aisle > Skylight Actuator Group > Skylight
Actuator 1 > Running Parameters, set DI1 alarm level to Low voltage alarm or High
voltage alarm, and click Submit.
 Set DI1 alarm level to Low voltage alarm if the smoke sensor is connected over NO; set DI1
alarm level to High voltage alarm if the smoke sensor is connected over NC.
 This section describes how to set DI1 alarm severity. For other settings, you can refer to this section.
Normal Connection Status
Smoke sensor AI/DI_1 DI
alarm or DI1_smoke alarm is
displayed on the active alarm
page of the app or WebUI.
Copyright © Huawei Technologies Co., Ltd.
5 Power-On Commissioning
Alarm Clearance Method
 If AI/DI_1 sensor type is set
to Smoke Sensor, power off
and reset the smoke sensor to
clear the alarm.
 If AI/DI_1 sensor type is set
to Smoke Sensor(NC), press
the reset button of the smoke
sensor to clear the alarm.
126