Table of Contents
Advertisement
2.9. Control Input / Output Interface Specifications
2.9.1. CN2 and CN5 Connectors: Control I/O Signal Connectors
2.9. Control Input / Output Interface Specifications
2.9.1. CN2 and CN5 Connectors: Control I/O Signal Connectors
l Table 2-15 shows types of connectors that are used for connectors CN2 and CN5, and
connectors for user side devices.
Table 2-15
Connectors for Driver Unit
Mating connectors
(User device side)
Mating connector shell type
(User device side)
l The followings are wiring precautions for the connectors CN2 and CN5.
！ Caution : Check for wiring mistake in the polarity of external power supply, and
CN2
CN5
CN2
CN5
CN2
CN5
* These connectors will be provided with the Driver Unit.
à B3 and 23 type Driver Units do not have connector CN5.
1)
Use shielded cable for wiring of the connectors CN2 and CN5.
2)
Be sure to use twisted cables for the pulse train input and the position feed back
signals.
3)
These cables should be laid separately from the power line. Wiring length shall be
short as possible. (2 m maximum)
4)
Connect one end of shield to the frame ground. Refer to "3.3.4. Ground Connection
and Wiring."
shorting between connector pins.
Japan Aviation Electronics Industry, Ltd.
Japan Aviation Electronics Industry, Ltd.
Japan Aviation Electronics Industry, Ltd.
— 2-27 —
B
B
3
3
t
t
y
y
p
p
e
e
B
B
5
5
t
t
y
y
p
p
e
e
2
3
t
y
p
e
2
5
t
y
p
e
2
3
t
y
p
e
2
5
t
y
p
e
DBLC-J25SAF-13L9
DCLC-J37SAF-13L9
DB-25PF-N*
DC-37PF-N*
DB-C15-J10-F2*
DC-C8-J13-F1-1*
Advertisement
Table of Contents
Troubleshooting
