Table of Contents
Advertisement
B
B
3
3
t
t
y
y
p
p
e
e
B
B
5
5
t
t
y
y
p
p
e
e
2
3
t
y
p
e
2
5
t
y
p
e
2
3
t
y
p
e
2
5
t
y
p
e
7.1.3. Interruption of Positioning (STP)
l Turning ON the STP input will stop the Motor in the middle of a positioning with the RS-232C
position command, Programmable Indexer, and Jog.
l Though the shipping set of deceleration of the STP input is to bring a sudden stop, you may alter
the its deceleration setting. (Refer to the parameter MD.)
l The STP input is only effective for positioning operations in the RS-232C position command,
Programmable Indexer and Jog. It is ineffective for the operation by the pulse train command
input or the analog command.
Figure 7-4
STP input
RS-232C position
command or
RUN input
Motor rotation
IPOS input
(FW £ 0)
ON
OFF
ON
OFF
MA
CW or CCW
velocity
Closed
Open
à The start commands for positioning such as RUN (Positioning start), HOS (Home
Return) and JOG (Jog) are ineffective while the STP input is ON.
à The STP input may not be accepted when the signal does not remain ON for 10 ms or
longer.
à When the Motor stops by the STP input, the IPOS output does not close in case of the
FIN format (parameter FW>0).
à When the acceleration set by the parameter MD is less than the parameter MA, the
Motor decelerates along the parameter MA.
à In case of analog command or torque command operation through the RS-232C
communication, the DC command will be cleared to zero when the STP input is ON.
10 ms min
10 ms max
RUN input invalid.
MD
— 7-3 —
7.1. General Operation and Function
7.1.3. Interruption of Positioning (STP)
10 ms max
Advertisement
Table of Contents
Troubleshooting
