The Cursor Control Keys - Agilent Technologies HP E5574A User Manual

If you have started an
application, you can
directly access all relevant
settings.
These settings apply to all
the measurements you
take.
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Introducing the HP E5574A Optical Loss Analyzer
The OLA Front Panel Keys
With the softkeys, the cursor control keys, or the rotary knob you
can choose any application. To start the highlighted application
press S or E
ELECT NTER
I Use this key to invoke the "Select Instrument" menu. You
NSTR
can check or change the settings of the light source, the polarization
controller, and the powermeter.
S O /O Use this key to turn the internal laser light
OURCE N FF
source on or off. The "Source on" indicator lamp shows the current
state.
S Use this key to invoke the "System Configuration" screen.
YST
You can check and change the current HP-IB address of the
instrument.
P Use this key to check and to change the general
RESET
instrument settings for the measurement sensitivity and for the
display of measured values.
ATTEN TI O N Pressing this key does not reset the instrument to
power-up defaults!
A Use this key to display the status of the software presently
UX
installed.
H Use this key to invoke the built-in help system.
ELP
E Use this key to confirm the selection of a menu item or to
NTER
terminate the manual input of a numerical parameter value.

The Cursor Control Keys

The use of the cursor control keys depends on the application.
↑ / ↓ Use these keys to either move the cursor on the display or to
decrement/increment the highlighted parameter value.
→ / ← If the upper right-hand corner of the window frame on the
display shows > or <, you use these keys to proceed to a second
page or to return to the previous page.
28
or A once more.
PPL