Table of Contents
Advertisement
command
syntax
description
parameter
related commands
example
command
syntax
description
parameter
related commands
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
HP-IB Programming
IEEE Common Commands
*SAV
*SAV<wsp><location
With the SAVe command *SAV the instrument setting is stored in
RAM. You can store settings at locations 1 - 9. The scope of the
saved setting is identical to the standard setting (see *RST).
The RAM location: 1 ≤ location ≤ 9.
*RCL
OUTPUT 724;"*SAV 3"
*SRE
*SRE<wsp><value>
The Service Request Enable command *SRE sets bits in the
Service Request Enable register.
Any logical '1' in the enable register enables the corresponding bit
in the Status register.
The register is cleared at power-on. The *RST and *CLS
commands do not change the register.
The bit value for the register: 0 ≤ value ≤ 255.
Bit
Mnemonic
7 (MSB)
Operation Status
6
Request Status
5
Event Status Bit
4
Message Available
3
Questionable Status
2
Not used
1
Not used
0 (LSB)
Not used
Note: Bit 6 cannot be masked.
*SRE?
115
Decimal Value
128
64
32
16
8
0
0
0
Advertisement
Chapters
Table of Contents
