Agilent Technologies HP E5574A User Manual page 250

-168
-200
-201
-202
-220
-221
-222
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Appendix F. Error Messages
HP-IB Messages
Block data not allowed.
Block data was found where none is allowed.
Execution Errors (-200 to -299)
These are error messages in the range -200 to -299. They show that
an execution error has been detected by the execution control block.
An execution error is signalled by the execution error bit (bit 4) in
the event status register.
Execution error.
This shows that an execution error has occurred but the control
block cannot be more specific.
Invalid while in local.
This command is invalid because in conflicts with the configuration
under local control.
Settings lost due to rtl.
A local setting was lost when the instrument was changing from
remote to local control, or from local to remote control.
Parameter error.
This shows that a parameter error has occurred but the control block
cannot be more specific.
Settings conflict.
A valid parameter was received, but could not be used during
execution because of a conflict with the current state of the
instrument.
Data out of range.
The data, though valid, was outside the range allowed by the
instrument.
248