Agilent Technologies HP E5574A User Manual page 138

Optical loss analyzer
Table of Contents

Advertisement

parameter
response
errors
example
command
syntax
description
parameter
response
errors
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
HP-IB Programming
OLA Specific Commands
1|2
1
Reads head A
2
Reads head B
Default is 1.
The measured value in dB or percent, depending on the current
setting of the measurement unit (see ":SENSe:POWer:UNIT").
The message "Wrong application for this command" is returned, if
the present application is not Coupler Test or Polarization
Dependent Coupler Test.
The message "No head connected" is returned, if there is only one
or no optical head attached to the instrument.
The message "No valid result possible" is returned, if the value
could not be measured.
OUTPUT 724;":SENS1:DATA? SR"
ENTER 724;A$
:SENSe:DATA? STAB
:SENSe[1|2]:DATA?<wsp>STAB
This query returns the stability value. It is only applicable to the
Stability application, which can only be started if an application is
active.
1|2
1
Reads head A
2
Reads head B
Default is 1.
The measured value in dB.
The message "Wrong application for this command" is returned, if
the present application is not Stability.
The message "No head connected" is returned, if there is no optical
head attached to the specified channel.
The message "No valid result possible" is returned, if the value
cannot be measured.
136

Advertisement

Table of Contents
loading

Table of Contents