Configuring The Member Switch; General Steps For The Member Switch - Allied Telesis AlliedWare Plus GS980MX Series Installation Manual

Configuring the Member Switch

General Steps for
the Member
Switch
This section contains the procedures for configuring the member switches
of the stack
Note
The procedures require reseting the switch. Some network traffic will
be lost if the unit is already connected to an active network.
You need to know the following to perform these procedures:
How many member switches will be in the stack?

Which 5Gbps ports will be used as the stack trunk on the master

and member switches? Refer to "Stack Trunks" on page 63.
The procedures should be performed in the order presented here.
The procedure for configuring member switches for stacking is divided into
two parts. The general steps to Part I are listed here:
1. Start a local management session on the switch.
2. View the hardware status and management software version number
with the SHOW SYSTEM ENVIRONMENT and SHOW VERSION
INSTALLED commands in the Privilege Exec mode.
3. Enable the VCStack feature with the STACK ENABLE command in the
Global Configuration mode. You will probably not have to perform this
step because the default setting for the feature is enabled.
4. Assign an ID number in the range of 2 to 4 to the member switch with
the SWITCH RENUMBER command in the Global Configuration
mode.
Note
Changing a member switch's ID does not delete the default ID 1
from its configuration. Instead, the member switch retains it and
uses default ID 1 as the provisioned master switch.
5. Save your changes with the WRITE command in the Privilege Exec
mode.
6. Restart the switch with the REBOOT command.
GS980MX Series Installation Guide for Virtual Chassis Stacking
201