Removing Outer Parts; Cylinder Head And Valves - Kubota BX24 Workshop Manual

BX24, RCK54(P)-23BX, RCK60B-23BX, LA240, BT601, WSM

(2) Removing Outer Parts

(3) Cylinder Head and Valves

Draining Coolant, Radiator, Air Cleaner and Muffler etc.
CAUTION
• Never open the radiator cap while operating or immediately
after stopping. Otherwise, hot water will spout out from the
radiator. Wait for more than ten minutes to cool the radiator,
before opening the cap
1. Set the engine stands (9) to the crankcase.
2. Open the radiator drain plug, and remove radiator cap to
completely drain the coolant.
3. After all coolant is drained, close the drain plug.
4. Loosen the inlet hose band and the radiator hose bands, and
remove the radiator (1) with the radiator hoses (2) and the air
cleaner (3).
5. Loosen the fan belt. Remove the alternator (6), the starter motor
(8), the fan and the fan belt.
6. Remove the heat proof cover (7), the muffler (5) and the exhaust
manifold.
Coolant Capacity
(1) Radiator
(2) Radiator Hose
(3) Air Cleaner
(4) Inlet Hose
(5) Muffler
Cylinder Head Cover
1. Disconnect the breather hose (1).
2. Remove the cylinder head cover screws (2).
3. Remove the cylinder head cover (3).
(When reassembling)
• Check to see if the cylinder head cover gasket is not defective.
Tightening torque Cylinder head cover screw
(1) Breather Hose
(2) Cylinder Head Cover Screws
Injection Pipes
1. Loosen the screws to the pipe clamp (1).
2. Detach the injection pipes (2).
(When reassembling)
• Sent compressed air into the pipes to blow out dust. Then,
reassemble the pipes in the reverse order.
Tightening torque Injection pipe retaining nut
(1) Pipe Clamp
1-S25
ENGINE
2.7 L
Radiator 2.85 U.S.qts
2.38 Imp.qts
0.4 L
Radiator
0.42 U.S.qts
tank
0.35 Imp.qts
(6) Alternator
(7) Heat Proof Cover
(8) Starter Motor
(9) Engine Stand
W1051348
6.86 to 11.3 N·m
0.7 to 1.15 kgf·m
5.1 to 8.3 ft-lbs
(3) Cylinder Head Cover
W1028468
24.5 to 34.3 N·m
2.5 to 3.5 kgf·m
18.1 to 25.3 ft-lbs
(2) Injection Pipe
W1028640
KiSC issued 08, 2019 A