Installation Procedure - HP 98568A Installation Instruction

HP 9121/9122 Flexible Disk Drives
Installation Procedure
The following procedure describes how to connect your HP 9121 and 9122 to
your Series 300 computer. Before you do this, however, refer to the manual(s)
that came with the drive to:
• Unpack the drive.
• Check the voltage switch setting.
• Check the fuse value.
And now, the installation procedures ...
1.
Play It Safe.
Turn your computer and disk drive off, if they are not already off.
2. Select Your Interface.
Use either the built-in HP-IB interface or an HP 98624A HP-IB
3. Set the Address.
a. On the back of the disk drive, find the set of four switches labeled
"ADDRESS."
b. Set the HP-IB address:
• If there is only one other disk or tape drive (besides this HP 9121/22)
already connected to the interface, set the "ADDRESS" switches to 2
as shown in Figure 6-16, unless address 2 has already been used.
[ji
X 4 2 1
1 • •
o
• •
Address 2
Figure 6-16.
Address 2
6-66 Adding Mass Storage Devices