HP 98568A Installation Instruction page 84

HP 98248B Floating-Point Accelerator
3. Check to see whether the bottom slot in the computer is empty. If it is,
remove the slot cover plate. It it is occupied, renlove the board and place it
elsewhere in the cOlnputer or expander. If it is the processor board, place it
in the slot next to the bottom.
4. Remove the Floating-Point Accelerator board from the packaging nlaterial
and place it on top of the packaging material.
Fl. Locate the FPA Bus Cable. (Note: the cable lllay already be installed on
the Accelerator. If so, skip down to step 8.)
6. Locate the FPA Bus connectors on the Accelerator as shown in Figure 4-1.
Figure 4-1. Floating-Point Accelerator Bus Connectors
7. Attach one end of the FP A Bus Cable to the connectors. Make sure that
the edge with the large notch is toward the side of the board, as shown in
Figure 4-2.
4-8 Adding Accessory Cards