Installation Procedure - HP 98568A Installation Instruction

HP 7936H/7937H Disk Drives
Installation Procedure
Your HP Customer Engineer will unpack and install your disk drive for you.
The following procedure describes how to connect your disk drive to your Series
300 computer.
Caution
Do not attempt to operate the unit until it is moved to the
installation site and the spindle and actuator are unlocked.
Do not apply any sudden mechanical shocks to the unit.
1. Play It Safe.
a. Make arrangements with your HP Customer Engineer to have your disk
drive unpacked and installed.
b. Turn your computer and disk drive off, if they are not already off.
2. Select Your Interface.
The HP 7936H and 7937H disk drives are supported only on a high-speed
HP-IB interface such as the HP 9S625A/B Disk Interface.
3. Set the Address.
a. On the back of the disk drive, find the set of four switches in the upper
left-hand corner.
b. Set the HP-IB address:
• If this is the first or only disk or tape drive connected to the interface,
set the switches to 0 as shown in Figure 6-11.
I)
.
....
•
•
Address 0
Figure 6-11.
Address 0
Adding Mass Storage Devices 6-37