HP 98568A Installation Instruction page 310

HP 9133D/H/L and 9134D/H/L Disk Drives
HP 9133/34 Disk Drive
Connected to Built-in HP-IB Interface (Select Code 7)
(Continued)
File Major Minor Interleave
Device Name
Path
Name* Type Number Number * * Factor * * *
HP 9133 - Flexible
HP 9133 - Flexible
/dev/dsk/#sO
b
/dev/rdsk/#sO c
o
4
Ox070n10
Ox070n10
2
2
NOTE: In this table, refer only to the entries for the number of volumes you
selected. If you have one volume (default configuration), only the "1st vol."
entry applies to your disk.
*
**
***
6-84
#
is a number that identifies the disk drive (e.g., 0 for the root disk, 1 for
the next disk installed, etc.). Replace
#
with any unique number, and
use the same number in both the /dev/dsk and /dev/rdsk entries (e.g.,
jdev jdskj1s0 and jdev jrdskj1s0). Record the numbers on the Chapter 6,
"Mass Storage" tab.
n is a number that identifies the address (set in step 3 of the Installation
Procedure). Replace n with a 0 if the address was set to 0, use 2 if the
address was set to 2, and so on.
For an HP 98620B DMA Card, the recommended interleave factor for the
hard disk is 4 instead of 7.
Adding Mass Storage Devices