HP 98568A Installation Instruction page 156

HP 98628A Datacomm Interface
b. Set the Remote switch as follows:
• If you are connecting a terminal to this interface and want the
terminal to be the system console, set this switch to 0 (remote),
which is opposite that shown in Figure 5-24. Be aware that the boot
ROM will not recognize this terminal as the system console, even
though HP-UX will. No boot ROM messages will appear on the
associated terminal; therefore, do not use the HP 98628A as a system
console until after HP-UX is installed .
• If you are connecting a terminal to this interface but do not want
the terminal to be the system console, set this switch to 1 (OFF) as
shown in Figure 5-24.
5. Set the Protocol Switch.
SKIPSTEP?
If you will not be using this interface for networking with an
HP 1000 computer (via the HP DSN/Data Link protocol), then
you can skip to step 6. The protocol switch is preset for the
Async protocol and need not be changed for most applications.
a. Find the Default switch group by referring to Figure 5-24. Switch 0 in
this group is the protocol switch.
b. Set the protocol switch as follows:
• If you want the Async protocol, used with most connections, set
switch 0 to 0 as shown in Figure 5-24 .
• If you want the HP DSN /Data Link protocol, used in networking with
an HP 1000 host computer, set switch 0 to 1, which is opposite that
shown in Figure 5-24.
5-60 Adding Interface Cards