HP 98568A Installation Instruction page 272

HP 7941, 7942, 7945, 7946
Disk and Disk/Tape Drives
Worksheet Entries
You have now installed your HP
7941/42/45/46
Disk Drive.
The following "Worksheet Entries" contain information needed to use your disk
drive with the HP-UX operating system. Refer to the entries for the interface
you will be using.
Copy this information to a worksheet (worksheets are found at the end of
Chapter 1, "Getting Started") or remember to refer here when you need it.
When finished, you will be ready to install your next peripheral. If you
have installed all of your peripherals, refer to the Series 300 HP- UX System
Administration Tasks manual that came with your HP-UX operating system.
Table 6-14.
HP 7941/42/45/46
Connected to HP 98625 Disk Interface (Select Code 14)
Device
Path*
File Major
Minor **
Interleave
Name Name Type Number Number Factor
HP 7941/42/45/46 - Disk
/dev/dsk/#sO
b 0 OxOeOnOO
1
HP 7941/42/45/46 - Disk
/dev/rdsk/#sO c 4
OxOeOnOO
1
HP 7942/46 - Tape
/dev/ct/#sO
b 0 OxOeOn10
1
HP 7942/46 - Tape
/dev/rct/#sO
c
4
OxOeOn10 1
*
#
is a number that identifies the disk drive (e.g., 0 for the root disk, 1 for the
next disk installed, etc.). Replace
#
with any unique number, and use the same
number in both the /dev/dsk and /dev/rdsk entries (e.g., /dev/dsk/lsO and
/dev /rdsk/lsO). Record the numbers on the Chapter 6, "Mass Storage" tab.
**
n is a number that identifies the address (set in step 3 of the Installation
Procedure). Replace n with a 0 if the address was set to 0, use 2 if the address
was set to 2, and so on.
6-46 Adding Mass Storage Devices