HP 98568A Installation Instruction page 88

HP 98556A
20 Graphics Accelerator
2. Remove the video (RGB) cable from the video board.
3. Remove the video board and place it on a static-free surface.
4. Insert the Graphics Accelerator into the connector on the video board.
Make sure it is firmly seated.
5. Turn the board pair so that the video board is facing up and the Graphics
Accelerator is facing down. Insert and tighten the three screws that
correspond with stand-offs on the Graphics Accelerator. Then turn
the assembly over and insert and tighten the fourth screw in the hole
corresponding with the stand-off on the video board.
6. Install the board pair into the expander or computer. Make sure it is firmly
seated into the connector.
7. Connect the video cable.
8. Connect the power cord to the computer.
INSTALLATION COMPLETE!
Do You Have Another Accessory Card to Add?
NO
Proceed to Chapter 5, "Interface Cards".
YES Refer to the table of contents for this chapter to find
where your next installation instructions begin.
4-12 Adding Accessory Cards