HP 98568A Installation Instruction page 315

HP 9144A Tape Drive
Address 2
Figure 6-18.
Address 2
• If there are two other disk or tape drives (besides this HP 9144A)
already connected to the interface, set the "ADDRESS" switches to 3
as shown in Figure 6-19, unless address 3 has already been used. Refer
to the manual that came with your tape drive for additional switch
settings.
~ X421
• •
o • •
Address 3
Figure 6-19.
Address 3
4. Connect the Tape Drive to Your Computer.
a. Find the HP-IB cable provided with the tape drive.
b. Connect one end of the HP-IB cable to the HP-IB socket on the back of
the tape drive. Tighten the thumb screws to secure the connection.
c. Connect the other end of the HP-IB cable to the interface.
Adding Mass Storage Devices 6-89