HP 98568A Installation Instruction page 157

HP 98628A Datacomm Interface
6. Set the Baud Rate.
a. Find the Default switch group by referring to Figure 5-24. Switches 1
thru 3 in this group determine the baud rate.
b. Set the baud rate switches as follows:
• If connecting an HP 2601A printer or an HP 92205A/C Hayes
Smartmodem 1200 to this interface, set the baud rate switches to
1200. To get 1200 baud, set switch 3 to 1, and set switches 2 and 1 to
O. The switches will look like this:
Figure 5-26.
• If connecting a terminal or an HP 2686 LaserJet printer to this
interface, set the baud rate switches to 9600. To get 9600 baud, set
switches 3, 2 and 1 to 1 as shown in Figure 5-24.
• If connecting an HP 39800/01A Bar Code Reader to this interface, set
the baud rate switches to 2400. To get 2400 baud, set switches 3 and
1 to 1, and set switch 2 to
O.
The switches will look like this:
Figure 5-27.
• If connecting any other device to this interface, set the baud rate
switches to match the baud rate of the device. See the installation
manual that came with the interface for all baud rate settings.
Adding Interface Cards 5-61