HP 98568A Installation Instruction page 507

HP 92916A Bar Code Reader
Worksheet Entries
You have now installed your HP 92916A Bar Code Reader.
The following "Worksheet Entries" contain information needed to use your bar
code reader with the HP-UX operating system.
Copy this information to a worksheet (worksheets are found at the end of
Chapter 1, "Getting Started") or remember to refer here when you need it.
When finished, you'll be ready to install your next peripheral. If you have
installed all of your peripherals, refer to the Series 300 HP- UX System
Administration Tasks manual that came with your HP-UX operating system.
Note
HP-HIL devices can be added to or removed from the HP-HIL
interface without affecting the HP-UX operating system.
However, if your application requires the use of a particular
device and you remove the device from the link, open the
link to the device, or open the link to add a new device, your
application might not recognize the change and may not work
as expected.
Table 10-19.
HP 92916A Bar Code Reader
Worksheet Entries
Path File Major Minor
' "
Power
Device Name Name
Type
Number Number
Req.
HP 92916A /dev/r8042
c 23 OxOOOOOO
133 rnA
HP 92916A /dev/wand
c
24 OxOOOO20 133 rnA
* The second minor number in the table assumes the bar code reader is the second
device on the HP-HIL interface (address=2). If this is not the case, substitute
the correct position (address) of the bar code reader in place of the 2 in the
minor number (e.g., if the bar code reader is the third device on the interface,
the minor number would be OxOOOO30).
Adding Miscellaneous Peripherals 10-65