HP 98568A Installation Instruction page 404

HP 9111 A Graphics Tablet
Address 7
Figure 8-2.
Address 7
4. Connect the HP 9111A to the Computer.
a. Get an HP-IB cable.
b. Connect one end of the HP-IB cable to the HP-IB connector on the
back of the graphics tablet. Tighten the thumb screws to secure the
connection.
c. Connect the other end of the HP-IB cable to the interface.
Note
If the interface already has several cables connected to it,
connect the plotter's cable to one of the other devices on the
interface.
5. Connect the Power Cord.
Connect the female end of the power cord to the power socket on the back
of the graphics tablet, and connect the other end to your power outlet.
6. Record the Address.
Make a note that address 6 (or the alternate address you chose in step 3)
has been used and is no longer available on the interface you selected. You
can use the "Address Record" form on the Chapter 6, "Mass Storage" tab
for this purpose.
8-10 Adding Plotters & Other
GraDhics Devices