HP 98568A Installation Instruction page 329

HP 9153A/9154A Disk Drives
HP 9153/54 Disk Drive
Connected to HP 98624 HP-IB Interface (Select Code 8)
(Continued)
Path File Major Minor Interleave
Device Name Name
...
Type Number Number
......
Factor
HP 9153 - Flexible /dev/dsk/#sO b
0 Ox080n10
2
HP 9153 - Flexible
/dev/rdsk/#sO
c
4
Ox080n10 2
NOTE: In this table, refer only to the entries for the number of volumes you
selected. If you have one volume (default configuration), only the "1st vol."
entry applies to your disk.
*
**
***
#
is a number that identifies the disk drive (e.g., 0 for the root disk, 1 for
the next disk installed, etc.). Replace
#
with any unique number, and
use the same number in both the /dev/dsk and /dev/rdsk entries (e.g.,
/dev /dsk/1s0 and /dev /rdsk/1s0). Record the numbers on the Chapter 6,
"Mass Storage" tab.
n is a number that identifies the address (set in step 3 of the Installation
Procedure). Replace n with a 0 if the address was set to 0, use 2 if the
address was set to 2, and so on.
For an HP 98620B DMA card, the interleave factor for the hard disk is 2
instead of 3.
... ......
Adding Mass Storage Devices 6-103