Worksheet Entries - HP 98568A Installation Instruction

HP Plotter (HP-IB Interface)
Worksheet Entries
You have now installed your plotter.
The following "Worksheet Entries" contain information needed to use your
plotter with the HP-UX operating system. Refer to the entries for the select
code you will be using.
Copy this information to a worksheet (worksheets are found at the end of
Chapter 1, "Getting Started") or remember to refer here when you need it.
When finished, you'll be ready to install your next peripheral. If you have
installed all of your peripherals, refer to the Series 300 HP- UX System
Administration Tasks manual that came with your HP-UX operating system.
Table 8-1.
Plotter
Connected to Built-in HP-IB Interface (Select Code 7)
Path* File Major
Minor **
Device Name Name
Type
Number
Number
Plotter
/dev/plt7440 c
21
Ox070nOO
*
If you have a plotter other than the HP 7440A, substitute the model number of
your plotter for 7440 in the path name.
** n is a number that identifies the address (set in step 3 of the Installation
Procedure)' ReDlace n with a 5 if the address was set to 5. use 7 if the address
was set to 7, and so on.
8-6 Adding Plotters & Other
Graphics Devices