HP 98568A Installation Instruction page 338

HP 7957/58/59S SCSI Disk Drives
Worksheet Entries
You have now installed your 7957/58/59S Disk Drive. Remember that the
terminator must be terminating the SCSI bus (step 4-b above).
The following "Worksheet Entries" contain information needed to use your disk
drive with the HP-UX operating system. Refer to the entries for the interface
you will be using.
Copy this information to a worksheet (worksheets are found at the end of
Chapter 1, "Getting Started") or remember to refer here when you need it.
When finished, you will be ready to install your next peripheral. If you
have installed all of your peripherals, refer to the Series 300 HP- UX System
Administration Tasks manual that came with your HP-UX operating system.
Table 6-36.
HP7957/58/59S SCSI Drive
Connected to HP 98265A Interface (Select Code 14)
Path
File Major Minor Interleave
Device Name
Name * Type Number Number **
Factor
HP 7957/58/59S
/dev/dsk/#sO b 7
OxOeOnOO
1
HP 7957/58/59S
/dev/rdsk/#sO
c
47 OxOeOnOO 1
*
**
#
is a number that identifies the disk drive (e.g. 0 for the root, 1 for
the next disk installed, etc.). Replace
#
with any unique number, and
use the same number in both the /dev/dsk and /dev/rdsk entries (e.g.
/dev /dsk/lsO and /dev /rdsk/lsO). Record the numbers on the Chapter 6,
"Mass Storage" tab.
n is a number that identifies the address (set in step 3 of the Installation
Procedure). Replace n with a 1 if the address was set to 1, use 4 if the
address was set to 4, and so on.
6-112 Adding Mass Storage Devices