Adding Mass Storage Devices - HP 98568A Installation Instruction

6
Adding Mass Storage Devices
_ HP Series 6100 Model 600/ A HP-IB _ HP 7957/58/59B and 7961/62/63B
CD-ROM Drive Disk Drives
- HP Series 6300 Model 20GB/ A Optical - HP 7957/58/598 SCSI Disk Drives
- HP 7974A Tape Drive
Disk Library 8ystem
_ HP Series 6300 Model 650/ A Optical
- HP 7978A Tape Drive
Disk Drive _ HP 7979A, 7980A, and 7980XC Tape
- HP 7907 A Disk Drive Drives
- HP 7911, 7912, 7914 Disk/Tape Drives _ HP 9121 and 9122 Flexible Disk Drives
- HP 7933 and 7935 Disk Drives _ HP 91258 and 9127 A Flexible Disk
- HP 7936H and 7937H Disk Drives
_ HP 7941/42 and 7945/46 Disk/Tape
Drives
- HP 7957 A and 7958A Disk Drives
Drives
- HP 9133 and 9134 Disk Drives
- HP 9144A Tape Drive
- HP 9153A and 9154A Disk Drives
- HP 9895A Disk Drive
Are You Adding Any of the Above Mass Storage Devices?
NO Proceed to Chapter 7, "Printers".
YES Set mass storage device's HP-IB address to 0, 2 or
3, and interface to preset select code (7 for built-in
HP-IB,
14
for HP 98625 Disk Interface, or
8
for HP
98624 HP-IB). Otherwise, see the next entry in this
chapter, "Determining HP-UX Minor Numbers".
Then refer to the table of contents on the previous
page to find where your installation instructions begin.
Adding Mass Storage Devices 6-1