HP 98568A Installation Instruction page 237

Note
HP Series 6300 Model 650/ A
Optical Disk Drive
You cannot use address 7 because the host system SCSI
controller uses address 7.
Table 6-3.
SCSI Settings
SCSI Address Switch 6 Switch 7 Switch 8
0
Off Off Off
1
Off Off On
2
Off
On Off
3
Off On On
4
On Off Off
5
On Off On
6
On On Off
• Address 0 should be used if this address is not currently used by any
other device on the bus.
• If Address 0 is used by another device, select any other bus address not
used by another device.
3. Connect the Disk Drive to Your Computer.
a. Turn your computer and disk drive off, if they are not already off.
b. Attach the cable coming from the SCSI interface of your computer to
one of the two connectors on the rear panel of the disk drive (it does not
matter which one). Press in fully.
c. If either connector on the rear panel is not being used to connect
to another SCSI device, the unused connector must be terminated.,
Attach the terminator (supplied with the SCSI interface card) to the
unused connector on the disk drive. Press in fully. If you do not have
a terminator, you will need to order one. The HP part number is
1252-2297.
Adding Mass Storage Devices 6-11