Worksheet Entries - HP 98568A Installation Instruction

HP 7911/7912/7914 Disk/Tape Drives
Worksheet Entries
You have now installed your HP 7911/12/14 Disk/Tape Drive.
The following "Worksheet Entries" contain information needed to use your
disk/tape drive with the HP-UX operating system. Refer to the entries for the
interface and select code you will be using.
Copy this information to a worksheet (worksheets are found at the end of
Chapter 1, "Getting Started") or remember to refer here when you need it.
When finished, you will be ready to install your next peripheral. If you
have installed all of your peripherals, refer to the Series 300 HP- UX System
Administration Tasks manual that came with your HP-UX operating system.
Note
If you have a dual controller device, refer to the separate tape
controller tables for your tape minor number.
Table 6-7.
HP 7911/12/14
Connected to HP 98625 Disk Interface (Select Code 14)
Path*
File Major
Minor **
Interleave
Device Name Name Type Number Number Factor
HP 7911/12/14 - Disk
/dev/dsk/#sO b
0 OxOeOnOO
HP 7911/12/14 - Disk
/dev/rdsk/#sO c 4
OxOeOnOO
HP 7911/12/14 - Tape
/dev/ct/#sO
b 0 OxOeOn10
HP 7911/12/14 - Tape
/dev/rct/#sO c 4 OxOeOn10
*
Replace
#
with any unique number, and use the same number in both the
/dev/dsk and /dev/rdsk entries (e.g., /dev/dsk/1s0 and /dev/rdsk/1s0).
Record the numbers on the Chapter 6, "Mass Storage" tab.
1
1
1
1
** n is a number that identifies the address (set in step 4 of the Installation
Procedure). Replace n with a 0 if the address was set to 0, use 2 if the address
was set to 2, and so on.
Adding Mass Storage Devices 6-27