Hp 7941, 7942, 7945, 7946 Disk And Disk/Tape Drives - HP 98568A Installation Instruction

Installation Procedure
HP 7941, 7942, 7945, 7946
Disk and Disk/Tape Drives
The following procedure describes how to connect your HP 7941, 7942, 7945
and 7946 to your Series 200/300 computer. Before you do this, however, refer
to the manual(s) that came with the drive to:
• Unpack the drive.
• Check the voltage selector switch.
• Check the fuse value.
And now, the installation procedure ...
1. Play It Safe.
Turn your computer and disk drive off, if they are not already off.
2. Select Your Interface.
Select one of the following interfaces, listed in order of preference for
optimum disk performance:
• HP 98625 Disk Interface
• Built-in HP-IB Interface
3.
Set the Address.
a. On the back of the disk drive, find the set of four switches labeled
"ADDRESS."
b. Set the HP-IB address:
• If there is only one other disk or tape drive (besides this HP
7941/42/45/46) already connected to the interface, set the
"ADDRESS" switches to 2 as shown in Figure 6-14, unless address 2
has been used elsewhere.
Adding Mass Storage Devices 6-43